universalnax.blogg.se - Ems topgun 3 vs aimtrak vs arcade guns

Note that as calibration is performed at the corners, this is the most critical area regarding sensor detection.

LEDs not pointed in the approx direction of the gun.

Min distance is approx 2 ft for 19in monitor and 3 ft for 28 in. The most likely cause of failure to calibrate would be: If this continues to be the case you might need to install the Config software to diagnose the problem. If any of the above steps fails, the cursor will continue to point at the required location and not advance to the next stage. Note the position to aim is offset to the left of the screen center-line.

The cursor will then point near the lower edge of the screen.

The cursor will then point to a location near the top right corner.

The timing is not important as the cursor is an indicator only. Aim the gun at the cursor and pull the trigger again.

The mouse cursor will eventually start to move and come to rest, pointing at a location near the top left corner of the screen, and begin to flash.

Hold the trigger for 5 seconds (this value can be changed, see later).

Players which are very different heights will not easily be able to share a gun.

This means if you intend to look through the gun-sights when playing you must do this when calibrating, or if you "shoot from the hip" you must do this when calibrating. Note that the gun calibration must be done at the height the gun will be used at. Hold the gun at the approximate location you will be using it. The gun must be held vertically during this process otherwise it will fail. Recoil power is adjustable in the Aimtrak Utility (see below)Ĭalibration is only required once. This type of power supply is often available on Ebay. The pictures below show the cable connection and an example supply. We have tested this 3A supply from an Ebay vendor and it gives stronger recoil than some 4A supplies: The center pin of the connector is positive. If using two or more guns you will need one supply per gun. The power supply needs to have the following maximum specs:,ĭO NOT use a supply with a current capability of greater than 4 amps as the mechanism relies on the current-limiting feature on the supply to prevent overload. The recoil power is routed via the connecting cable and the power supply needs to have a connector with outer diameter of 5.5mm and inner of 2.1mm. Recoil guns are shipped without recoil power supply.

Recoil Power Requirement (Guns with recoil option only)